[F777]IKB4

It's amazing that scenarios from IKB3 works on IKB4 too (but not all). I think the scenarios that go beyond Bad Rinckenstadt may be broken due to the addition of the SFS tunnel, but I haven't tested them yet

Niederkirch ready. Until I hang the section dividers (streckentrenner) on the wire, I need to go to Altenburg and replace the entire wire there, and then move from Koblenz to Bad Rinckenstadt.

I don't know about you all, but I really like the result. The only nuance is the tension masts with wires for wire holders. I mean this:

In reality, as I understood it, from the topmost wire, which runs in an arc from mast to mast, wires go to the bottom only where the wire holders of the contact network are located. But in the TSC package, everything here is done with a grid. I know that there are tools for manually stretching all these wires, but I already sat with one mast for about 2 days trying to figure out all the subtleties. That's why I decided to simplify my life a lot. I don't know how critical this is for you. If I ever have a wish (after the project is finally released) to change it, I will do it. At the same time, it will be possible to hang isolators more realistically so that they really isolate the wires from each other, and not just the holders themselves.