Can't swap Locs in editor (CTD)

LCYCowboy · 19. September 2019

Hi,

I just bought the fantastic Hausach - Villingen and I thought I would have a test drive. I went into the editor (as usual) and swapped the Loc from the vR189 to the vR189 EL in the first scenario (freight to Villingen), but when I drive the scenario, after a couple of minutes (as I approach the first Bahnübergang).

I started trouble shooting. Whenever I replace any Loc to a VR EL loc using the editor (I have tried several routes) I get a crash just after starting the scenario (the screen freezes and I have to close TS2019 using the Task Manager).

It never did this before.

Any experts able to help?

I forgot to say, using the default loc works fine!

**Thor** · 19. September 2019

@LCYCowboy
Occurs if the scenarios use a „rolling start“. Have a look in the scenarios folder if there are files named like „rolling save“ or similiar (can‘t verify right now).
Delete these and try again.

Maybe the reason, there might be other situations causing same message and crash.

LCYCowboy · 19. September 2019

I thought I had fixed with a new graphic driver install, but it is still happening.

These scenarios are starting with a train standing still waiting for the signal to change to green.

I seem to be able to drive any original scenario, but whenever I change the train to an EL variant, it crashes after about 1 minute of actually driving!

**Thor** · 19. September 2019

@LCYCowboy checked the scenarios and none of them makes use of Rolling Start. So I am sorry my hint won't help you
Will try to swap the engines for myself and see what happens -> works fine for me using vR 189.

LCYCowboy · 20. September 2019

Thanks for helping.

Did it work swapping to one of the vR EL engines (I tried both the 189 and 151) using the train simulator editor?

Can't swap Locs in editor (CTD)

Teilen

Benutzer online in diesem Thema